0 грн.

Checkout

Complex remedy for de-caking XADO RED ANTICARBON 320 ml

Reviews:
(0)
  • Product Code: XA 41011
  • Availability: In Stock
  • Series: XADO Series: https://xadoindustrial.com/en/xado-en/
299 грн.
Contact the manager
Enter the phone number and we will call you back
This product has a minimum quantity of 20
  • Product overview
  • Downloads
  • Reviews (0)
  • Questions (0)

XADO RED ANTICARBON
A comprehensive de-carbonizing agent.
A new formula of a fast-acting agent for softening and removing complex carbon deposits on the bottom and rings of
pistons of gasoline and diesel engines. Removes all carbon deposits and resinous contaminants from the cavities of the cylinder-piston
group cavities.
Benefits:

  • Restores mobility of the rings.
  • Cleans cylinders and pistons, combustion chambers, valves from all types of contaminants (soot, coke, varnishes, resins).
  • Equalizes compression in the cylinders.
  • Removes deposits from spark plugs (glow plugs).
  • Safe for catalytic converters, oxygen sensors, rubber products and seals.

Application:
1. Warm up the engine. The engine should be warm, but not hot.
2. Unscrew the spark plugs (injectors or glow plugs). Disconnect the ignition timing sensor connector, the Hall
Hall sensor, or switch. Shut off the fuel supply to the cylinders.
3. Spray the agent through the hose nozzle into each cylinder in turn (up to 5 seconds). Reinstall the spark plugs (injectors or glow plugs)
glow plugs) back in, thus ensuring that the composition does not evaporate. Wait for 10-20 minutes.
4. Unscrew the spark plugs (nozzles). Cover the spark plug holes with an absorbent cloth so that the dirt that comes out does not
get on the paintwork of the vehicle body parts. Crank the engine with the starter for several
seconds. Repeat the procedure 2-4 times.
5. In order to avoid “dry” friction when starting the engine after cranking, it is recommended to add 10 mg of fresh engine oil to each
cylinder with 10-15 mg of fresh engine oil. Replace the spark plugs (injectors or glow plugs),
connect the wires and sensors, and turn on the fuel supply.
6. Start the engine and allow it to run at an increased crankshaft speed for up to 15 minutes. During this
time, the residues of softened coke will be removed through the exhaust system*.
* For complete removal of residual contaminants from the cylinders, it is recommended to drive on a country road for 5-10 km at
at the maximum permissible speed.
Dosage: one 320 ml aerosol can is enough for decoking in 20 cylinders.
Ingredients: multifunctional additives, hydrocarbons, REVITALIZANT, hydrocarbon propellant gas.

Downloads
XADO RED ANTICARBON (916.57KB) Download technical data sheets (tds)
Reviews (0)

There are no reviews for this product.

Questions (0)

No questions about this product, be the first and ask your question.