Revitalization of industrial presses

Presses

What the use of revitalizant gives:

• Reduction of ovality and taper in compressor and main motion cylinders of air hammers to 0.15 mm;
  
• reduction of gaps and elimination of micro wear of guides of hammers, presses and dies;
  
• stabilization of hydraulic systems operation;
  
• increase of resource in 1,5 - 2 times.
  

Applications:

Compressors of pneumatic hammers

Compressors of pneumatic hammers are treated with "HADO Gel-Revitalizant for compressors and bearings" in 3 stages without oil change at the rate of 1.5 ml per 1 liter of standard oil for one stage of treatment.

The interval of total operating time between treatment stages is 8-12 hours.

Full cycle of treatment is not less than 450 hours of compressor operation, calculated from the beginning of the first stage of treatment.

Hammer main cylinders

Hammer main motion cylinders are treated in 3 stages by adding "HADO Gel-Revitalizant for compressors and bearings" to the lubrication system of the cylinder-piston group at the rate of 1.5 ml of gel per 1 liter of lubricating oil for one stage of treatment.

The interval of total operating time between treatment stages is 8-12 hours.

Complete cycle of treatment of the main motion cylinder not less than 450 hours of total operating time of the hammer from the beginning of the first stage.

Hammer, press and die guides

Guides of hammers, presses and dies are treated with "HADO Gel-Revitalizant for compressors and bearings (industrial)" by adding the necessary amount of gel to the oil bath at the rate of 9.0 ml per 1 liter of standard oil for the whole treatment cycle.

A full cycle of treatment of guides is not less than 700 hours of total operation of the machine.